MV-ELA

From NeoGeo Development Wiki
Revision as of 08:48, 19 February 2017 by Furrtek (talk | contribs) (Repair infos)
Jump to navigation Jump to search
MV-ELA schematic

External board provided with original MVS cabs to generate high voltage and switch it to the marquee's MV-ELB board(s).

Uses a 5 pin transformer and a C2516 transistor to form a self-oscillating step-up circuit.

Uses six 800mA 400V AC0V8 triacs (datasheet) for switching outputs.

Often produces a high-pitched noise when some panels are lit, this is normal and common with switching PSUs. If the noise is too annoying, replace the transformer. LED mods can also be found.

Software control is done through registers REG_LEDDATA, and REG_LEDLATCHES.

Be careful when manipulating this board when powered: touching the high voltage section can hurt A LOT. After disconnecting power, it shouldn't keep a dangerous charge for long (a few seconds).

MV-ELA top
MV-ELA bottom, HV cap

Repair

If the step-up circuit stalls, the transistor may short 5V to ground. Both resistors near the "MAIN PCB" connector will act as fuses and burn out.

In this case, replace:

  • The C2516 transistor
  • Both power input resistors (R3 and R4)
  • Capacitors and resistors in the feedback circuit (C1, C2, R1 and R2)
  • The transformer, if any winding is open

If the step-up circuit works but some or all panels don't light up, check the triacs first, then the logic chips.