MVS cartridge pinout: Difference between revisions

From NeoGeo Development Wiki
Jump to navigation Jump to search
mNo edit summary
mNo edit summary
Line 20: Line 20:
The [[BIOS]] was written to ensure the signal is asserted when it does the slot check.
The [[BIOS]] was written to ensure the signal is asserted when it does the slot check.


[[NG:DEV.TEAM]] carts run this signal to the LPC2468FBD208. Seems never used on official PCBs. --[[User:Hpman|Hpman]] 05:22, 26 June 2012 (CEST)
[[NG:Dev.Team]] carts run this signal to the LPC2468FBD208. Seems never used on official PCBs. --[[User:Hpman|Hpman]] 05:22, 26 June 2012 (CEST)


[[PROGEOP]] uses SLOTCS, not [[PROGSF1]]. --[[User:Furrtek|Furrtek]] 12:11, 24 September 2012 (CEST)
[[PROGEOP]] uses SLOTCS, not [[PROGSF1]]. --[[User:Furrtek|Furrtek]] 12:11, 24 September 2012 (CEST)


[[Category:Cartridge systems]]
[[Category:Cartridge systems]]

Revision as of 14:04, 3 January 2013

See also AES cartridge pinout.

CHA bottom CHA top PROG bottom PROG top

Beware ! Pinouts found elsewhere have /ROMOE and 4MB swapped, it's an error on the original schematics. /ROMOE is on pin 33 bottom, 4MB is on pin 34 bottom.

See Signal names for the description of each pin.

SLOTCS goes low when the slot is used. On multi-slot boards, the signals come from NEO-F0 SLOT0~5. On one slot boards, it's tied to SYSTEMB. The BIOS was written to ensure the signal is asserted when it does the slot check.

NG:Dev.Team carts run this signal to the LPC2468FBD208. Seems never used on official PCBs. --Hpman 05:22, 26 June 2012 (CEST)

PROGEOP uses SLOTCS, not PROGSF1. --Furrtek 12:11, 24 September 2012 (CEST)