NEO-273

From NeoGeo Development Wiki
Revision as of 02:35, 12 May 2017 by Furrtek (talk | contribs)
Jump to navigation Jump to search
Package QFP64R
Manufacturer
First use 1992 ?
Used on MVS cartridges

The NEO-273 chip is used in cartridges to replace discrete 74LS273 and 74LS174 latches that were used in early boards (like on CHA-32). It demultiplexes the P bus to C ROM and S ROM addresses.

This chip was later replaced by NEO-CMC which performs the same functions along with a lot of other things.

For cartridges that use this chip but have more than 8MiB of sprite graphics data, extra bits were added using discrete chips. An added 74LS74 (2 bits) in CHA256 boards for example increases the C ROM capacity from 8MiB to 32MiB (256Mbits).

Demultiplexing

  • The C ROM address is latched on the rising edge of PCK1B.
  • The S ROM address is latched on the rising edge of PCK2B.

See P bus.

P BUS P19 P18 P17 P16 P15 P14 P13 P12 P11 P10 P9 P8 P7 P6 P5 P4 P3 P2 P1 P0
C address A3 A2 A1 A0 A20 A19 A18 A17 A16 A15 A14 A13 A12 A11 A10 A9 A8 A7 A6 A5
S address A4 A2 A1 A0

P20~23 are left out or routed to additional latches.

A /C_A20 signal is available on pin 47 to allow cartridges which use 2MiB C ROMs to switch between 2 pairs without the need for an additional inverter chip.

Internals

It includes one 16-bit latch (to address a 128KiB S ROM) and one 20-bit latch (to address 8MiB of 2*16bits C ROMs).

Note that A4 (CA4) of the C ROMs and A3 (2H1) of the S ROM are not part of the P bus and come straight from the cartridge edge, bypassing this chip.

Pinout

File:Neo-273 pinout.png

OpenOffice Draw file: File:Neo-273.odg