NEO-AES4-1 board: Difference between revisions

From NeoGeo Development Wiki
Jump to navigation Jump to search
No edit summary
m (Category)
 
(3 intermediate revisions by the same user not shown)
Line 1: Line 1:
Seems to be the sixth and latest board revision. Some (all?) units have a metal shield.
[[File:4-1.jpg|thumb|Neo Geo AES 4-1 board]]


[[File:4-1.jpg]]
Seems to be the sixth and latest board revision.
 
Some (all ?) units appear to be heavily shielded with a metal cover and conductive coating on the plastic shell.
 
=Differences with the [[NEO-AES3-6 board]]=
 
* The power supply circuit was (finally) moved next to the power connector.
* Most through-hole chips were replaced by their surface mount versions.
* The PLCC version of the [[68k]] CPU was used. Also tiny Z80.
* The [[System_ROM|SP1 ROM]] is an OTP part.
* Resistor networks were added on bus lines, maybe as an attempt to reduce radiated noise.
* TC9018P composite sync generator.
* {{Sig|SYNC|SYNC}}/NEW-SYNC jumper.
* {{Sig|BNKB|BNKB}}/RBNKB jumper.
 
[[Category:Cartridge_systems]]

Latest revision as of 11:34, 29 December 2018

Neo Geo AES 4-1 board

Seems to be the sixth and latest board revision.

Some (all ?) units appear to be heavily shielded with a metal cover and conductive coating on the plastic shell.

Differences with the NEO-AES3-6 board

  • The power supply circuit was (finally) moved next to the power connector.
  • Most through-hole chips were replaced by their surface mount versions.
  • The PLCC version of the 68k CPU was used. Also tiny Z80.
  • The SP1 ROM is an OTP part.
  • Resistor networks were added on bus lines, maybe as an attempt to reduce radiated noise.
  • TC9018P composite sync generator.
  • SYNC/NEW-SYNC jumper.
  • BNKB/RBNKB jumper.