NEO-ZMC: Difference between revisions

From NeoGeo Development Wiki
Jump to navigation Jump to search
m (Removed incorrect logic def)
Line 14: Line 14:
{{Pinout|NEO-ZMC|512}}
{{Pinout|NEO-ZMC|512}}


Pins 10, 11, 12 are certainly not connected since the addressing scheme doesn't allow mapping over 512KiB.
Are pins 10, 11, 12 higher address bits ?


* SDA0, SDA1, SDA8~15: Z80 address bus
* SDA0, SDA1, SDA8~15: Z80 address bus

Revision as of 00:43, 11 December 2020

Package SOIC24
Manufacturer
First use 1995 ?
Used on cartridges

Z80 Memory Controller. Provides a hardwired 32KiB bank and switchable 16, 8, 4, and 2KiB banks arranged as a register file. To save pins, the Z80's upper address lines (A15~A18) are used for data input. The chip's write strobe is port address decoded inside the system.

Pinout


Edit this pinout

Are pins 10, 11, 12 higher address bits ?

  • SDA0, SDA1, SDA8~15: Z80 address bus
  • M1 A11~M1 A18: M1 ROM address lines
  • SDRD0: Decoded write signal from NEO-D0 (latch on rising edge)

Operation

SDA8~15 is used for the bank number (data), SDA0 and SDA1 for selecting the bank zone.

SDA1 SDA0 Z80 port Bank zone Address range Size Latch size
0 0 $08 0 $F000~$F7FF 2KiB 8 bits
0 1 $09 1 $E000~$EFFF 4KiB 7 bits
1 0 $0A 2 $C000~$DFFF 8KiB 6 bits
1 1 $0B 3 $8000~$BFFF 16KiB 5 bits

Details

SDRD0 must be high before configuring banks.

To configure a bank to be accessed (e.g. bank 0 in the $8000~$BFFF range):

  • Set SDRD0 low (prepare for new bank configuration, outputs are tri-stated)
  • Set SDA0~15 = $8003 (select bank 0 and 16k range size) Why $8003 and not just $0003 ?
  • Set SDRD0 high (latch bank, ready to convert inputs to proper output signals)
  • Now, when the Z80 reads the $8000~BFFF range, NEO-ZMC will map this to the M1 ROM zone $00000~$03FFF;

To configure a bank to be accessed (e.g. bank 1 in the $8000~$BFFF range):

  • Set SDRD0 low (prepare for new bank configuration, outputs are tri-stated)
  • Set SDA0~15 = $8103 (select bank 1 and 16k range size) Why $8103 and not just $0103 ?
  • Set SDRD0 high (latch bank, ready to convert inputs to proper output signals)
  • Now, when the Z80 reads the $8000~BFFF range, NEO-ZMC will map this to the M1 ROM zone $04000~$07FFF;