Pinouts: Difference between revisions

From NeoGeo Development Wiki
Jump to navigation Jump to search
(7 intermediate revisions by the same user not shown)
Line 1: Line 1:
=A/V connector=
[[File:Av_pinout.png]]
Note: Some home consoles revisions appear to only provide composite video, no separate sync signal.
=Cartridges=
=Cartridges=


See the [[AES cartridge pinout]] and [[MVS cartridge pinout]] pages.
* [[AES cartridge pinout]]
* [[MVS cartridge pinout]]


=Joypad ports=
=Joypad ports=


Special "deep" DE-15 male connectors with plastic shell. 10 inputs, 3 outputs.
Special, deep DA-15 connectors with a plastic shield. 10 direct inputs, 3 outputs, 2 power lines.


Inputs are pulled high to +5V by [[CRE401]] RC arrays.
Inputs are pulled high to +5V by [[CRE401]] R-C arrays.


Outputs are open collector through 22 ohms resistors.
Outputs are open collector through 22 ohms resistors (not pulled high).


<center>[[File:Joypad_pinout.png]]</center>
<center>[[File:Joypad_pinout.png]]</center>
Line 19: Line 26:
=Memory card=
=Memory card=


See [[Memory_card#Card_pinout|Memory card]].
See [[Memory card pinout]].


=MVS boards=
=MVS boards=
Line 27: Line 34:
=[[Multiplayer]] jack=
=[[Multiplayer]] jack=


To do. Stereo only !
RS-485 pair + ground. Use a stereo cable only !
 
* Sleeve: Ground
* Ring: D-
* Tip: D+


=CD/CDZ=
=CD/CDZ=


See [[CD module]].
==Power supply connector==
 
[[File:Cdpow_pinout.png]]
 
See [[power supply]].


==YM2610 digital audio==
==YM2610 digital audio==
[[File:Cd2_cn7.jpg|Cd2_cn7.jpg]]
[[File:Cd2_cn6.jpg|Cd2_cn6.jpg]]
Clock, L, R ?
 
# OP0
# PHI
# SH2
# SH1
# Analog


==Video and CDDA==
==Video and CDDA==
[[File:Cd2_cn1cn3.jpg|400px]]
[[File:Cd2_cn1cn3.jpg|400px]]
R, V, B, S, Burst, GND ?
Clock, L, R ?


==CD reader==
Video:
# Red
# Green
# Blue
# Sync
# Burst
# GND
 
CDDA:
# LRCK
# DATA
# BCLK
 
==CD drive==
[[File:Cd2_cn4.jpg|400px]]
[[File:Cd2_cn4.jpg|400px]]
See [[CD drive]].


==Power==
==PCB power==
[[File:Cd2_cn5.jpg]]
[[File:Cd2_cn5.jpg]]
# 5V CD
# 10V CD
# 5V logic
# Ground


[[Category:Chips]]
[[Category:Chips]]
[[Category:Base system]]
[[Category:Base system]]

Revision as of 18:59, 6 September 2018

A/V connector

Note: Some home consoles revisions appear to only provide composite video, no separate sync signal.

Cartridges

Joypad ports

Special, deep DA-15 connectors with a plastic shield. 10 direct inputs, 3 outputs, 2 power lines.

Inputs are pulled high to +5V by CRE401 R-C arrays.

Outputs are open collector through 22 ohms resistors (not pulled high).

JAMMA

See JAMMA connector pinout.

Memory card

See Memory card pinout.

MVS boards

See MVS board connectors pinouts.

Multiplayer jack

RS-485 pair + ground. Use a stereo cable only !

  • Sleeve: Ground
  • Ring: D-
  • Tip: D+

CD/CDZ

Power supply connector

See power supply.

YM2610 digital audio

Cd2_cn6.jpg

  1. OP0
  2. PHI
  3. SH2
  4. SH1
  5. Analog

Video and CDDA

File:Cd2 cn1cn3.jpg

Video:

  1. Red
  2. Green
  3. Blue
  4. Sync
  5. Burst
  6. GND

CDDA:

  1. LRCK
  2. DATA
  3. BCLK

CD drive

File:Cd2 cn4.jpg See CD drive.

PCB power

File:Cd2 cn5.jpg

  1. 5V CD
  2. 10V CD
  3. 5V logic
  4. Ground