Difference between revisions of "Pinouts"
m (→CD/CDZ) |
m (→YM2610 digital audio) |
||
(6 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
+ | =A/V connector= | ||
+ | |||
+ | [[File:Av_pinout.png]] | ||
+ | |||
+ | Note: Some home consoles revisions appear to only provide composite video, no separate sync signal. | ||
+ | |||
=Cartridges= | =Cartridges= | ||
− | + | * [[AES cartridge pinout]] | |
+ | * [[MVS cartridge pinout]] | ||
=Joypad ports= | =Joypad ports= | ||
− | Special | + | Special, deep DA-15 connectors with a plastic shield. 10 direct inputs, 3 outputs, 2 power lines. |
− | Inputs are pulled high to +5V by [[CRE401]] | + | Inputs are pulled high to +5V by [[CRE401]] R-C arrays. |
− | Outputs are open collector through 22 ohms resistors. | + | Outputs are open collector through 22 ohms resistors (not pulled high). |
<center>[[File:Joypad_pinout.png]]</center> | <center>[[File:Joypad_pinout.png]]</center> | ||
Line 19: | Line 26: | ||
=Memory card= | =Memory card= | ||
− | See [[ | + | See [[Memory card pinout]]. |
=MVS boards= | =MVS boards= | ||
Line 27: | Line 34: | ||
=[[Multiplayer]] jack= | =[[Multiplayer]] jack= | ||
− | + | RS-485 pair + ground. Use a stereo cable only ! | |
+ | |||
+ | * Sleeve: Ground | ||
+ | * Ring: D- | ||
+ | * Tip: D+ | ||
=CD/CDZ= | =CD/CDZ= | ||
+ | |||
+ | ==Power supply connector== | ||
+ | |||
+ | [[File:Cdpow_pinout.png]] | ||
+ | |||
+ | See [[power supply]]. | ||
==YM2610 digital audio== | ==YM2610 digital audio== | ||
− | [[File: | + | [[File:Cd2_cn6.jpg|Cd2_cn6.jpg]] |
− | + | ||
+ | # OP0 | ||
+ | # PHI | ||
+ | # SH2 | ||
+ | # SH1 | ||
+ | # Analog | ||
==Video and CDDA== | ==Video and CDDA== | ||
[[File:Cd2_cn1cn3.jpg|400px]] | [[File:Cd2_cn1cn3.jpg|400px]] | ||
− | |||
− | |||
− | ==CD | + | Video: |
+ | # Red | ||
+ | # Green | ||
+ | # Blue | ||
+ | # Sync | ||
+ | # Burst | ||
+ | # GND | ||
+ | |||
+ | CDDA: | ||
+ | # LRCK | ||
+ | # DATA | ||
+ | # BCLK | ||
+ | |||
+ | ==CD drive== | ||
[[File:Cd2_cn4.jpg|400px]] | [[File:Cd2_cn4.jpg|400px]] | ||
− | See [[CD | + | See [[CD drive]]. |
− | == | + | ==PCB power== |
[[File:Cd2_cn5.jpg]] | [[File:Cd2_cn5.jpg]] | ||
+ | |||
+ | # 5V CD | ||
+ | # 10V CD | ||
+ | # 5V logic | ||
+ | # Ground | ||
[[Category:Chips]] | [[Category:Chips]] | ||
[[Category:Base system]] | [[Category:Base system]] |
Latest revision as of 19:59, 6 September 2018
Contents
A/V connector
Note: Some home consoles revisions appear to only provide composite video, no separate sync signal.
Cartridges
Joypad ports
Special, deep DA-15 connectors with a plastic shield. 10 direct inputs, 3 outputs, 2 power lines.
Inputs are pulled high to +5V by CRE401 R-C arrays.
Outputs are open collector through 22 ohms resistors (not pulled high).

JAMMA
Memory card
See Memory card pinout.
MVS boards
See MVS board connectors pinouts.
Multiplayer jack
RS-485 pair + ground. Use a stereo cable only !
- Sleeve: Ground
- Ring: D-
- Tip: D+
CD/CDZ
Power supply connector
See power supply.
YM2610 digital audio
- OP0
- PHI
- SH2
- SH1
- Analog
Video and CDDA
Video:
- Red
- Green
- Blue
- Sync
- Burst
- GND
CDDA:
- LRCK
- DATA
- BCLK
CD drive
See CD drive.
PCB power
- 5V CD
- 10V CD
- 5V logic
- Ground