Trace patching

From NeoGeo Development Wiki
Revision as of 23:08, 8 December 2016 by Furrtek (talk | contribs) (Created page with "thumb|Flying magnet wire patches on a shiny but lightly corroded board. Make sure to use the appropriate gauge when patching power traces, AWG 35 won't...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
Flying magnet wire patches on a shiny but lightly corroded board.

Make sure to use the appropriate gauge when patching power traces, AWG 35 won't allow 1 amp for long...

  • "Kynar" wire: Great. Get a good quality spool (high-temperature plastic).
  • Magnet wire: Good, easy to salvage but can be hard to solder.
  • Telephone wire: Can do the job for a few traces, but very rigid (and ugly).
  • Paper clip: No.
  • Tape: If temporary, why not. Might leave sticky residue.
  • Hot glue: Good, just don't make a mess and don't apply it to chip pins.
  • Nail varnish: Good, can take a while to dry. Easily removed with acetone.
  • Random glue: No, probably won't stick or will stick too much. Can also eat the board up.
  • Epoxy glue: NO. NEVER.