Displaying credits: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
m (Replaced D1 by D0 in the unit part of the code as D1 was displayed 2 times instead of D1 then D0) |
||
| Line 18: | Line 18: | ||
move.w d1,REG_VRAMRW ; Write tens to VRAM | move.w d1,REG_VRAMRW ; Write tens to VRAM | ||
andi.w #$000F,d0 ; Get units | andi.w #$000F,d0 ; Get units | ||
ori.w #$5030, | ori.w #$5030,d0 ; Same | ||
move.w | move.w d0,REG_VRAMRW ; Write units to VRAM | ||
</syntaxhighlight> | </syntaxhighlight> | ||
[[Category:Code]] | [[Category:Code]] | ||
Latest revision as of 10:00, 8 October 2018
The system ROM takes care of displaying the credits on the LED displays itself (see MV-LED board).
It's up to the game to display the counts on the screen when needed. SNK recommends using a 8x8 fix layer font.
The credit count for each player is stored in BCD in $D00034 for player 1, and $D00035 for player 2. These locations are in the backup RAM, to keep the credit counts in case of a power failure during play.
Note: SYSTEM_IO must be called each v-blank to update those locations.
moveq.l #0,d0
move.b $D00034,d0 ; Read P1 credits (hex)
move.w #$7088,REG_VRAMADDR ; Set position in fix map, top left
move.w d0,d1 ; Make a copy of the BCD value
move.w #$20,REG_VRAMMOD ; Auto-inc fix column
lsr.b #4,d1 ; Get tens
andi.w #$000F,d1 ; Mask off eventual garbage
ori.w #$5030,d1 ; Set palette 5 and tile offset $30 (ASCII "0")
move.w d1,REG_VRAMRW ; Write tens to VRAM
andi.w #$000F,d0 ; Get units
ori.w #$5030,d0 ; Same
move.w d0,REG_VRAMRW ; Write units to VRAM