JAMMA connector pinout: Difference between revisions
Jump to navigation
Jump to search
(Directions & links) |
m (→MVS pinout) |
||
Line 64: | Line 64: | ||
|bgcolor="#DD8844"|Right speaker | |bgcolor="#DD8844"|Right speaker | ||
|- | |- | ||
|[[Test | |[[Test button]] | ||
|[[File:Arrow_right.png]] | |[[File:Arrow_right.png]] | ||
|'''M''' | |'''M''' | ||
Line 85: | Line 85: | ||
|bgcolor="#4444FF"|Video blue | |bgcolor="#4444FF"|Video blue | ||
|- | |- | ||
|[[Service | |[[Service button]] | ||
|[[File:Arrow_right.png]] | |[[File:Arrow_right.png]] | ||
|'''R''' | |'''R''' |
Revision as of 12:35, 19 February 2017
MVS systems edge connectors aren't fully JAMMA compliant.
The pin pitch is .156in (3.96mm). There are 28 pins per side (key included), 56 total.
Many harnesses don't have the key to avoid accidentally plugging them backwards. Doing so will certainly fry the inputs chip (NEO-C1...).
Note that the G, I, O, and Q letters aren't used, to avoid confusion.
MVS pinout
Bottom | Top | ||||
---|---|---|---|---|---|
GND | A | 1 | GND | ||
B | 2 | ||||
+5V | C | 3 | +5V | ||
D | 4 | ||||
Unused | E | 5 | Unused | ||
+12V | F | 6 | +12V | ||
Key | H | 7 | Key | ||
Coin counter #2 | J | 8 | Coin counter #1 | ||
Coin lockout #2 | K | 9 | Coin lockout #1 | ||
Left speaker | L | 10 | Right speaker | ||
Test button | M | 11 | Mono audio | ||
Video green | N | 12 | Video red | ||
Video sync | P | 13 | Video blue | ||
Service button | R | 14 | Video GND | ||
Coin switch #4 P2 | S | 15 | Coin switch #3 P1 | ||
Coin switch #2 P2 | T | 16 | Coin switch #1 P1 | ||
P2 Start | U | 17 | P1 Start | ||
P2 Up | V | 18 | P1 Up | ||
P2 Down | W | 19 | P1 Down | ||
P2 Left | X | 20 | P1 Left | ||
P2 Right | Y | 21 | P1 Right | ||
P2 button A | Z | 22 | P1 button A | ||
P2 button B | a | 23 | P1 button B | ||
P2 button C | b | 24 | P1 button C | ||
P2 button D | c | 25 | P1 button D | ||
Select down | d | 26 | Select up | ||
GND | e | 27 | GND | ||
GND | f | 28 | GND |
Infos from [HardMVS.com]