Signals: Difference between revisions
Jump to navigation
Jump to search
m (Furrtek moved page Signal names to Signals: Not only names) |
No edit summary |
||
Line 1: | Line 1: | ||
{| class="regdef" | |||
|'''Name''' | |||
|'''Description''' | |||
|'''Type''' | |||
|'''Polarity''' | |||
|'''Comes from''' | |||
|'''Fault consequence''' | |||
|- | |||
|24M | |||
|24MHz master clock | |||
|Clock | |||
| | |||
|{{Chipname|NEO-D0}} | |||
|Nothing works | |||
|- | |||
|12M | |||
|12MHz clock (24/2) non-inverted | |||
|Clock | |||
| | |||
|{{Chipname|NEO-D0}} | |||
|Bad graphics | |||
|} | |||
*8M: 8MHz clock (24/3) non-inverted from LSPC | *8M: 8MHz clock (24/3) non-inverted from LSPC | ||
*6MB: 6MHz clock (24/4) inverted from NEO-D0 | *6MB: 6MHz clock (24/4) inverted from NEO-D0 |
Revision as of 07:51, 17 January 2016
Name | Description | Type | Polarity | Comes from | Fault consequence |
24M | 24MHz master clock | Clock | NEO-D0 | Nothing works | |
12M | 12MHz clock (24/2) non-inverted | Clock | NEO-D0 | Bad graphics |
- 8M: 8MHz clock (24/3) non-inverted from LSPC
- 6MB: 6MHz clock (24/4) inverted from NEO-D0
- 4M: 4MHz clock (24/6) non-inverted from LSPC
- 4MB: 4MHz clock (24/6) inverted from LSPC+AS04
- 1MB: 3MHz clock (24/8) inverted from NEO-D0
- 68KCLK: 12MHz clock (24/2) non-inverted from NEO-D0 (always equivalent to 12M ?)
- 68KCLKB: 12MHz clock (24/2) inverted from NEO-D0
- 2H1: S ROM A3
- A1~A23: 68k address bus
- A22I,A23I: A22 and A23 modified for 68k vector table swap
- AS: 68k Address Strobe
- BNK0~2: Memory card bank selection
- CA4: C ROMs A4
- C* or CR0~CR31: C ROMs data bus (2*16bits), holds data for one 8-pixels line
- D0~D15: 68k data bus
- /DTACK: 68k Data Transmit ACKnowledge, used to slow down acces to memory (see wait cycles)
- FIXD0~FIXD7: Fix layer data bus, holds data for 2 pixels
- P0~P23: C ROM, S ROM, LO ROM and internal address/data bus (multiplexed P bus)
- PA0~PA11: Palette RAM address bus
- PAL: Palette RAM address decode for 68k access
- PCK1B: Low 55ns, high 610 (1.5MHz) Clock to latch C ROM address from P0~P23 (mapping) on rising edge.
- PCK2B: Low 55ns, high 610 (1.5MHz) Clock to latch S ROM address from P0~P15 (mapping) on rising edge.
- /PORTADRS: $200000-$2FFFFF (P2+ ROM/Security chip) any access
- /PORTOEL: $200000-$2FFFFF (P2+ ROM/Security chip) odd byte read
- /PORTOEU: $200000-$2FFFFF (P2+ ROM/Security chip) even byte read
- /PORTWEL: $200000-$2FFFFF (P2+ ROM/Security chip) odd byte write
- /PORTWEU: $200000-$2FFFFF (P2+ ROM/Security chip) even byte write
- /PWAIT0, /PWAIT1: adds 0 to 3 cycle delay for P2 ROM reads, see wait cycles
- R/W: 68k Read/Write
- /ROMOE: $000000-$0FFFFF (P1 ROM) read
- /ROMOEL: $000000-$0FFFFF (P1 ROM) odd byte read
- /ROMOEU: $000000-$0FFFFF (P1 ROM) even byte read
- /ROMWAIT: add 1-cycle delay for P1 ROM reads
- /SROMOE: $C00000-$CFFFFF (System ROM) read
- /SROMOEL: $C00000-$CFFFFF (System ROM) odd byte read
- /SROMOEU: $C00000-$CFFFFF (System ROM) even byte read
- SDA0~SDA15 : Z80 address bus
- SDD0~SDD7: Z80 data bus
- SDRAD0~SDRAD7: ADPCM-A ROM multiplexed bus (data/address)
- SDRA8,SDRA9,SDRA20~SDRA23: ADPCM-A ROM address bus
- SDPAD0~SDPAD7: ADPCM-B ROM multiplexed bus (data/address)
- SDPA8,SDPA9,SDPA10,SDPA11: ADPCM-B ROM address bus
- SYSTEM: low when onboard ROMs selected
- SYSTEMB: inverted SYSTEM