Difference between revisions of "Coin counter"

From NeoGeo Development Wiki
Jump to: navigation, search
(Created page with "The coin counter should be a mechanical device used to count inserted coins. How does this work ? Apparently sinking current from it increments it. See {{Reg|REG_RESETCC1}},...")
 
m
 
(2 intermediate revisions by the same user not shown)
Line 1: Line 1:
The coin counter should be a mechanical device used to count inserted coins. How does this work ? Apparently sinking current from it increments it.
+
[[File:Coincounter.jpg|thumb|200px]]
  
See {{Reg|REG_RESETCC1}}, {{Reg|REG_RESETCC2}}, {{Reg|REG_SETCC1}}, and {{Reg|REG_SETCC2}}.
+
Not to be confused with the [[MV-LED|credits display]].
 +
 
 +
Coin counters are internal electromechanical devices used to count inserted coins in arcade cabs. They can only count up and should be made hard to reset.
 +
 
 +
The counters typically have one pin hardwired to +12V, and the other one connected to the MVS board by [[JAMMA_connector_pinout|JAMMA]] pins 8 and J. They are operated by software, not directly by the coin chutes.
 +
 
 +
=Control=
 +
 
 +
Only the [[system ROM]] should take care of this.
 +
 
 +
When writing to {{Reg|REG_SETCC1}} or {{Reg|REG_SETCC2}}, current flows through the counters, incrementing them. When {{Reg|REG_RESETCC1}} or  {{Reg|REG_RESETCC2}} are written to, current flow is stopped.
  
 
[[Category:Cartridge systems]]
 
[[Category:Cartridge systems]]

Latest revision as of 20:42, 26 December 2016

Coincounter.jpg

Not to be confused with the credits display.

Coin counters are internal electromechanical devices used to count inserted coins in arcade cabs. They can only count up and should be made hard to reset.

The counters typically have one pin hardwired to +12V, and the other one connected to the MVS board by JAMMA pins 8 and J. They are operated by software, not directly by the coin chutes.

Control

Only the system ROM should take care of this.

When writing to REG_SETCC1 or REG_SETCC2, current flows through the counters, incrementing them. When REG_RESETCC1 or REG_RESETCC2 are written to, current flow is stopped.