Watchdog: Difference between revisions
mNo edit summary |
m (Timing details) |
||
Line 1: | Line 1: | ||
The watchdog is | The watchdog is an anti lock-up (or security) measure to prevent games from freezing due to a bug or a glitch. It's a common feature of arcade hardware and many electronic systems. | ||
It consists of an internal resettable counter in {{Chipname|NEO-B1}} which resets the whole system if it goes over a certain value. To avoid this, the software needs to regularly reset the counter by writing any value to {{Reg|REG_DIPSW|REG_DIPSW}} ("kick" the watchdog). [[68k interrupts|VBlank]] routines typically take care of this task, but care has to be taken when the interrupt is disabled. | |||
The watchdog counter can be physically disabled by connecting pin {{Sig|DOGE|DOGE}} to ground (J2 jumper on some boards). This was probably done on development units. | |||
A constantly resetting system produces the [[click of death]]: a typical clicking sound, giving a clue for solving boot issues. | |||
The NeoGeo CD 2 also has a watchdog timer ? | |||
==Timings== | |||
This isn't verified. | |||
Charles mvstech.txt specifies this: | |||
<pre> | |||
/RESET low 3 244 030 cycles | |||
/RESET high 8 120 860 cycles | |||
Total time 11 364 890 cycles | |||
</pre> | |||
[[MAME]]'s source says that a 0.128762s long loop '''sometimes''' resets the system. | |||
Since the values are large and don't match simple binary numbers, the watchdog timer might have been implemented in NEO-B1 so it can be clocked by a slow video-related signal. This would also explain the variable behavior described in the MAME comment. | |||
*3244030 cycles is an extremely close match to the cycle count of exactly 8 [[Framerate|frames]] (0.135ms). | |||
*8120860 cycles is also a very close match to the duration of 20 frames (- 7 lines). | |||
*128762µs is 3090288 cycles, which corresponds to about 7.6 frames. | |||
Forcing a watchdog reset gives a steady 7.37Hz {{Sig|RESET|RESET}} signal, relating to the duration of 8 frames (135.67ms). | |||
==As a security measure== | |||
The watchdog is used as a form of | The watchdog is used as a form of protection on a number of games, previously this was implemented as a specific hack which locked a single address of [[Battery-backed RAM|SRAM]]. If the game doesn't find valid data in the backup ram it will initialize it, then sit in a loop. The watchdog should then reset the system. If the watchdog fails to reset the system the code will continue and set a value in backup ram to indiate that the protection check has failed. | ||
[[Category:Code]] | [[Category:Code]] | ||
[[Category:Base system]] | [[Category:Base system]] |
Revision as of 01:00, 4 May 2016
The watchdog is an anti lock-up (or security) measure to prevent games from freezing due to a bug or a glitch. It's a common feature of arcade hardware and many electronic systems.
It consists of an internal resettable counter in NEO-B1 which resets the whole system if it goes over a certain value. To avoid this, the software needs to regularly reset the counter by writing any value to REG_DIPSW ("kick" the watchdog). VBlank routines typically take care of this task, but care has to be taken when the interrupt is disabled.
The watchdog counter can be physically disabled by connecting pin DOGE to ground (J2 jumper on some boards). This was probably done on development units.
A constantly resetting system produces the click of death: a typical clicking sound, giving a clue for solving boot issues.
The NeoGeo CD 2 also has a watchdog timer ?
Timings
This isn't verified.
Charles mvstech.txt specifies this:
/RESET low 3 244 030 cycles /RESET high 8 120 860 cycles Total time 11 364 890 cycles
MAME's source says that a 0.128762s long loop sometimes resets the system.
Since the values are large and don't match simple binary numbers, the watchdog timer might have been implemented in NEO-B1 so it can be clocked by a slow video-related signal. This would also explain the variable behavior described in the MAME comment.
- 3244030 cycles is an extremely close match to the cycle count of exactly 8 frames (0.135ms).
- 8120860 cycles is also a very close match to the duration of 20 frames (- 7 lines).
- 128762µs is 3090288 cycles, which corresponds to about 7.6 frames.
Forcing a watchdog reset gives a steady 7.37Hz RESET signal, relating to the duration of 8 frames (135.67ms).
As a security measure
The watchdog is used as a form of protection on a number of games, previously this was implemented as a specific hack which locked a single address of SRAM. If the game doesn't find valid data in the backup ram it will initialize it, then sit in a loop. The watchdog should then reset the system. If the watchdog fails to reset the system the code will continue and set a value in backup ram to indiate that the protection check has failed.